Products
News
ContactUs
Donggua Fengcai Button Co.,Ltd.
Add: Building A, Shahukou Industrial Park, Changping Town, Dongguan City, Guangdong Province, China.
Rickie Li
TEL：+86--0769-83719835;
+86-- 0769-83719351/83719958
FAX：+86--0769-83719589
Email：china-yida@139.com
sales@fcbutton.com
sales@fcbutton.com
QQ：499879814
Wechat: 13192086703
Whatsapp: 13192086703
Phone nb: 13192086703
DISCUSS HOW TO DESIGN CLOTHING BUTTONS AND BUTTON HOLE POSITION
Catalog：新闻资讯Click to rate：
Published：2015-11-19 18:25:15
Changes of clothing styles can use all kinds of buttons, designers must design buttons according to the styles, highest possible taking consider of the reference line, the highest and the waist position as the new design starting point.
The upper hole position is the most important among buttonhole, it should be marked on the level line between the lapel and the basis points of lapel(barge line x).
Waist button is very important as well, which usually are located above the waist line, also can be below the waist line.In connection type of coat, only a piece of buckle (connection type double buttons), it is always located in the position of 2 cm above the waist line in order to prevent the lapel hogged. Current design often use middle position or lowest position, but in traditional style, narrow lapel suit often use high position. Two pieces of buckle are more convenient, and hole space depends on the styles, and normally button hole space is at least 6 cm (sometimes less),at most up to 1.5 cm (generally 9 to 10 cm).
Button among single-breasted styles, buttons and the hole distance to the corresponding edge, theoretically is equal or basic equal.This is especially suitable for narrow placket (2 to 3 cm) design, because here, button means at the centerline of the front.In fact, suit button usually is very close to seam allowance line, about 1 to 2 cm, and the buttons are often seamed in inner side of check mouth (preferably in the folding door), and sometimes innerward or outward moving into, to adjust the degree of clothing tightness.In this way, we don't have to go to move the Central Line distance (e.g., high button position suit jacket).
In double-breasted styles, distance between double button and the top line is mainly decided by the width of the placket. This style often have wide lapel, and button position will be below or above the waist line. If double-breasted is close to the former central Line, the distance usually is in 6 to 8 cm (button space is 10-11 cm);For traditional style with low lapel and low button position, its distance usually is 9 cm, even 10 cm (the button space is 14-15 cm).
When designing the buttons and button holes for double-breasted suit, button holes on the placket usually is marked with 1-2 cm distance from seam allowance, and then, in order to make convenient for stitching, in opposite side to measure the distance from center line to determine (linner) in the second button position line (of course, no button holes on this line). Button on the under closure, single-breased position usually is much more nearer to seam allowance to keep seam allowance of down folding door in the proper position.
